Build a second analog input for your Audigy-Page 2

Now the 2 pieces need to be joined.
I use J-B WELD for everything, it is
non-conductive.

Here is a fuzzy photo of the parts, (40 pin connector and stereo ins /outs), after being glued together.

Another alternative is to use an I/O adaptor made for hooking up your onboard sound, Unfortunately I found this after I had cut up the sound card. I leave it up to your imagination and a meter to figure out how to make the Aux cable for this.

Here is the connector for the 8 wire cable from the Line-In / MIC / Line-Out plugs. You need to use a stereo connector for the Aux Input so the Line-In or Line-Out will work. It might be easier to remember that you used an input labeled Line-In rather than Line-Out for future reference.

Introduction Page 1 Page 2 Page 3 Page 4 Page 5